Nema and Ball Screw
I got back to the shop and got the mount welded up. I also ran them though the sand blaster. This worked great after welding.
I had some problems welding these. I think I had too much gas flow.
After I popped them into the surface grinder. It was not really needed but it looks nice. Although it did make the 3", my target size.
Need to add an update here. The target of 3 inches was wrong. So after remaking the parts above at the right size of 2.75 inches. Not sure how I got to 3 inches. So I am back to where I was.
I had some problems welding these. I think I had too much gas flow.
After I popped them into the surface grinder. It was not really needed but it looks nice. Although it did make the 3", my target size.
Need to add an update here. The target of 3 inches was wrong. So after remaking the parts above at the right size of 2.75 inches. Not sure how I got to 3 inches. So I am back to where I was.
The next step is to build the mount from these to the rails. I plan on making these adjustable. This is to ensure that there is not a bind when the is rolling.